Say Y here to compile support for SCO over HCI USB.
+config BT_HCIBTUSB
+ tristate "HCI USB driver (alternate version)"
+ depends on USB && EXPERIMENTAL && BT_HCIUSB=n
+ help
+ Bluetooth HCI USB driver.
+ This driver is required if you want to use Bluetooth devices with
+ USB interface.
+
+ This driver is still experimental and has no SCO support.
+
+ Say Y here to compile support for Bluetooth USB devices into the
+ kernel or say M to compile it as module (btusb).
+
+config BT_HCIBTSDIO
+ tristate "HCI SDIO driver"
+ depends on MMC
+ help
+ Bluetooth HCI SDIO driver.
+ This driver is required if you want to use Bluetooth device with
+ SDIO interface.
+
+ Say Y here to compile support for Bluetooth SDIO devices into the
+ kernel or say M to compile it as module (btsdio).
+
config BT_HCIUART
tristate "HCI UART driver"
help
Say Y here to compile support for HCI BCSP protocol.
-config BT_HCIUART_BCSP_TXCRC
- bool "Transmit CRC with every BCSP packet"
- depends on BT_HCIUART_BCSP
+config BT_HCIUART_LL
+ bool "HCILL protocol support"
+ depends on BT_HCIUART
help
- If you say Y here, a 16-bit CRC checksum will be transmitted along with
- every BCSP (BlueCore Serial Protocol) packet sent to the Bluetooth chip.
- This increases reliability, but slightly reduces efficiency.
+ HCILL (HCI Low Level) is a serial protocol for communication
+ between Bluetooth device and host. This protocol is required for
+ serial Bluetooth devices that are based on Texas Instruments'
+ BRF chips.
+
+ Say Y here to compile support for HCILL protocol.
config BT_HCIBCM203X
tristate "HCI BCM203x USB driver"